Kitchen Drawer Organizer STL Generator
Kitchen drawers are usually much larger than a home printer's bed, so the trick is to print the organizer as modules that sit side by side. Start from this module and adjust it to your drawer.
The 3D preview loads automatically.
Planning a kitchen drawer in modules
A typical cutlery drawer is around 40–50 cm wide and 45–50 cm deep – far bigger than a 220 × 220 mm bed. Instead of one huge print, divide the drawer into a grid of boxes:
- Measure the drawer inside width and depth.
- Divide each number by the largest size your bed can print (for example 210 mm on a 220 mm bed, to leave room for a brim). Round up – that is how many modules you need in each direction.
- Subtract 2 mm of total clearance from the drawer size, then divide by the number of modules. That is the "Exact box size" of each module.
Example: a 420 × 460 mm drawer on a 220 × 220 mm bed → 2 × 3 modules. Each module: (420 − 2) / 2 = 209 mm wide and (460 − 2) / 3 ≈ 152.6 mm deep.
Compartment ideas
| Item | Compartment width | Tip |
|---|---|---|
| Forks, knives, spoons | 70–90 mm | Use rows = 1 so the compartment runs the full depth. |
| Teaspoons, small utensils | 50–60 mm | A shorter module (≈150 mm deep) works well at the front of the drawer. |
| Spatulas, ladles | 100–120 mm | Increase the height to 60 mm+ if the handles are thick. |
| Bag clips, twist ties | 40–50 mm | Use more rows to create small square cells. |
Food contact and cleaning
Standard PLA prints have tiny gaps between layers where food residue can collect, so treat 3D-printed organizers as storage for clean cutlery, not as food containers. Rounded inside corners (a radius of 5 mm or more) make them much easier to wipe out. Wash by hand in lukewarm water – most PLA softens in a dishwasher.
Other organizers
Drawer organizer generatorEnter your drawer size, pick the compartments and download a free, ready-to-print STL. Parametric, works in your browser, mm or inches.Desk drawer organizerDesign a 3D-printable desk drawer organizer for pens, cables and office supplies. Enter your drawer size and download a free STL.Small parts storage boxGenerate a 3D-printable compartment box for screws, nuts, beads or electronic parts. Choose the grid, get a free STL that fits your bed.